installation of my bow thruster system. I'm planning to put detail on this sub other have not done at least not yet
jims Tyhpoon TK-208 build
Collapse
X
-
Last edited by deepseadiver; 01-17-2019, 12:19 AM.Put your mind to it. If there's a will there's a way! -
Last edited by deepseadiver; 01-17-2019, 12:30 AM.Put your mind to it. If there's a will there's a way!Comment
-
Comment
-
-
Last edited by deepseadiver; 01-17-2019, 12:42 AM.Put your mind to it. If there's a will there's a way!Comment
-
Comment
-
Comment
-
-
I did it a little different for those push rods. I used regular servo horns. Also I found I need to reinforce the bend on the push rods to stop them flexing - very important for the rear dive plane servo for good depth keeping.2 PhotosComment
-
if I see any flex I may do the same . So far it looks solid when I work the servo between push rod and rudder.
Thanks
Jim :)Last edited by deepseadiver; 01-25-2019, 07:05 PM.Put your mind to it. If there's a will there's a way!Comment
-
Last edited by deepseadiver; 01-24-2019, 05:39 AM.Put your mind to it. If there's a will there's a way!Comment
-
Last edited by deepseadiver; 01-24-2019, 05:46 AM.Put your mind to it. If there's a will there's a way!Comment
-
Comment
-
Comment
Comment