Home

[RCSubGuy]

I slather it in there and let the excess press out. Wipe it off and you're good to go.

[RCSubGuy]

Oh my lord.... was I ever so young?...

[RCSubGuy]

No, I don't. I don't think I've done an R&R with a tandem antenna install yet....

[RCSubGuy]

Shot you an email, Casey!

[RCSubGuy]

The antenna extension should be plenty long enough to get down the central wire conduit and out the back of the boat. Your interference concern is valid,...

[RCSubGuy]

If your 3D printed parts are leaking, you're using the wrong print settings. I've never had an issue with air leaking on 3D printed parts.
...

[RCSubGuy]

Maybe I'm missing something, but I'd just drill the hole out round.

Done....

[RCSubGuy]

What Andy said above!

Just get a full, proper cylinder and simply don't use the ballast system. It will likely be the same price for a one-off...

[RCSubGuy]

Do NOT do infill at anything less than 100%. Water absolutely will get into the voids, causing a loss of buoyancy, and then it will also drain water for...

[RCSubGuy]

Don't get caught up in the digital side of things.

As CC said, mark the parts, assemble the parts, take stock and move forward. If you need...