Suggestions on how I should cut off excess stern planes rod? Should I use dremel cutting wheel, Snips, jewellers hand saw? I am afraid to blow out the interior mechanics!
New Trumpeter Kilo 1:144 Build
Collapse
X
-
If you used thin brass rods I think the Dremel will be able to cut it before you reach the plastic's melting point. If you want you could immerse the part in water, the water will act as a heat sink.Make it simple, make strong, make it work!Comment
-
Speaking of cutting in water, check this out
Make it simple, make strong, make it work!Comment
-
-
Comment