Home
Collapse
-
When your digit is thicker than the nail.😀 2 -
just wanted to it out after I saw this
https://youtu.be/kyrEdqApg9w?si=vAmWEoSMDFfRHKTs...Last edited by redboat219; 07-23-2024, 12:55 AM.Leave a comment:
-
Chatgpt designed pump based ballast system for RC submarine:
Designing a pump-based ballast system for an RC submarine involves a few key...Leave a comment:
-
ChatGPT designed ballast tank using wind shield washer pump:
Using a windshield washer pump for an RC submarine ballast tank system is a practical...Leave a comment:
-
AI designed Ballast System
Tried ChatGPT while I was doing laundry.
Designing a pump-based vented ballast tank system for an RC submarine
Here’s... -
Skipjack here
British Movietone clip
https://youtu.be/eoPwD5OkCZs?si=hJLkIgN6hQ8lcWJ9... -
Rear vertical "thruster", rear dive planes(between propeller shaft and stern cone) and swept back propellers.
Were vertical...Last edited by redboat219; 07-22-2024, 05:14 AM.Leave a comment:
-
love these electromechanical gizmos. Sure, there's Arduino but these actually move....Leave a comment:
-
-
A magnetic needle remote-controlled model submarines
Helmut Huhn and Heinrich Kistenich have developed a batch of remote-controlled...Leave a comment:
-
Some info I got off the web.
The control is done with a touch system. 16 sound channels are available to control each boat (4-way time-division...Last edited by redboat219; 07-20-2024, 10:15 PM.Leave a comment:
-
How long would these motor last before needing replacement running in lake, pond or swimming pool (chlorinated or salt)?
Would "motor...Last edited by redboat219; 07-15-2024, 10:16 PM.Leave a comment:
-
Resin compatibilty
When reinforcing seams and bonding GRP hull pieces to make Z-cuts which resin bond to which- polyester, epoxy, polyurethane.
Most resin available... -
Okey guys, on the count of three... ...
Last edited by redboat219; 07-12-2024, 11:53 AM.Leave a comment:
-
How about a towed water proof camera housing disguised as a V2 rocket submarine barge Prüfstand XII? ...
Leave a comment:
-
Too bad you no longer have 1/96 torpedo launchers. ....
Last edited by redboat219; 07-12-2024, 01:09 AM.Leave a comment:
-
-
Does Jake incorporate static grass/flock to replicate the "marine growth" on the hull?...
Leave a comment:
-
-
Could add a strip of plastic along the inside edge of the hull cut line to form a flange. Indexing pins in top hull assures proper alignment.
...Last edited by redboat219; 07-09-2024, 08:49 PM.Leave a comment:
No activity results to display
Show More
Leave a comment: