I used Nates suggestion on installing the brushless motor wiring!
I drilled three 1/8" holes through the end cap and ran one of the power wires through each hole. Now all that is left is to seal each of the wires to prevent leaking.
So far this brushless motor mounting system is going very well! Thanks again for the advice Nate!! :-))
Rob
"Firemen can stand the heat"
I drilled three 1/8" holes through the end cap and ran one of the power wires through each hole. Now all that is left is to seal each of the wires to prevent leaking.
So far this brushless motor mounting system is going very well! Thanks again for the advice Nate!! :-))
Rob
"Firemen can stand the heat"
Comment