Home

[neitosub]

Congrats on a successful run! Regarding the tendency to rise during a turn, did you notice the sub banking to the side while making the turn? If so,...

[neitosub]

I just run my linkage rods through the bellows and let friction hold them in place. The hole in the rubber bellow is so tight that it grips the rod and...

[neitosub]

Keep in mind that if you plan on just making components such as WTC trays, endcaps, and inner hull bulkheads, PLA and PLA+ is perfectly fine, as those...

[neitosub]

Looks great Rob!

Nate

[neitosub]

My next project after the Type IXc conversion. Already have an idea on how to make the waterline cut, everything after that looks to be pretty strai...

[neitosub]

You can run them on two separate channels but make sure to cut the red wire on one of the ESCs, on the 3-pin connector that goes to the receiver (not...