Thanks again Ken,
Very interesting subject materials. Our United States Navy has some great history!
Rob
"Firemen...
Home
Collapse
-
Again, thank you David!
This post will also be hard copied and put on my desk as a TOOL for how to apply different type of linkages.
...Leave a comment:
-
Thanks David,
Not only have you put up a mass of tool photos, but you also show how to use them! This post will be copied, printed out as...Leave a comment:
-
David,
I know that I have stated this before! But your skills for applying your authentic paint schemes and weathering to your boats is masterful....Last edited by rwtdiver; 04-20-2024, 06:24 PM.Leave a comment:
-
Thank you, Ken!
Thanks for taking the time to take such great photos, and posting them on our forum.! :-))
Looking forward to...Leave a comment:
-
Thanks Bob,
Should have known better!:-(( Pink could have been a better choice. I attached the foam, weights, and the velcro with silicon...Leave a comment:
-
Today I prepared our swimming pool for the summer and (cool morning sub runs)
I also made sometime to install the velcro...Leave a comment:
-
More work on the bottom hull section of the 212.
I have prepared the cylinder saddles for the Velcro hold down ties.
...Leave a comment:
-
I have managed to work in some sub building time today!
I have finished securing (gluing) using silicone adhesive the ballast...Last edited by rwtdiver; 04-15-2024, 01:31 PM.Leave a comment:
-
Your welcome Bob,
I knew for sure that both you and Ken have been following the Tally Ho. I have been following you on RC Groups as well....Leave a comment:
-
Never a boring rant Ken,
I really enjoy seeing what you and Bob are doing with your beautiful surface boat building.
Rob...Leave a comment:
-
Lots going on, but I am still finding some time to work on my 212!
I finished the installation of the foam inside the upper...Leave a comment:
-
Surface Boat Building
I am posting this up for you guys doing scale (full and modeling) surface boats.
Lofting the Lines; Part 1 - Rebuilding Tally Ho EP24 (y... -
Thanks Steven,
As for the Dremel tool! My wife knew that I had been looking at it, but, yes she is such a supporter of my hobbies, and I...Leave a comment:
-
Thanks Bill,
Yes! I do have a very special lady in my life, and she is all in with our hobby...
Rob
"Firemen can...Leave a comment:
-
Today looked like it was going to be a challenging day for sure!
I was going to start cutting the floatation foam for the...Last edited by rwtdiver; 04-06-2024, 04:51 AM.Leave a comment:
-
Hi Bruce,
These are the brass inserts that I use. I got them off Amazon. Using these in PLA is quite simple....Leave a comment:
-
Thanks David,
I will certainly make the change!
Rob
"Firemen can stand the heat."...Leave a comment:
-
wlambing (How about at least a first name on this forum)
I appreciate your input, and will make that change!:-))
Rob
"Firemen...Last edited by rwtdiver; 04-05-2024, 01:47 PM.Leave a comment:
-
I know some of my photos might be somewhat boring, but it is all part of the build!
I installed the brass inserts for the...Leave a comment:
No activity results to display
Show More
Leave a comment: