Moved the bow bell-crank to port side and made a couple of bends to allow the pushrod to travel along the side of the sub-driver. When the bell-crank was moved forward simulating a dive configuration, the pushrod and horn would hit that ridiculous wall I left there.
Took everything out and marked areas that needed to get excavated out. While I was at it might as well open up drainage too.
Using the same magnet arrangement as the Scamp (Skipjack) in her sail dive planes, I tested an idea for the bow planes control.
Here was a mockup to test the thought out, I think I will run with this setup.
Since I was opening up the bow for water flow, I went down the hull for all the styrene bulkheads.
Took everything out and marked areas that needed to get excavated out. While I was at it might as well open up drainage too.
Using the same magnet arrangement as the Scamp (Skipjack) in her sail dive planes, I tested an idea for the bow planes control.
Here was a mockup to test the thought out, I think I will run with this setup.
Since I was opening up the bow for water flow, I went down the hull for all the styrene bulkheads.
Comment