Looking for Either Canadian OR U.S Supplier of air hose as used by HWSNBN

[george]

I have sent you an email.
Thanks Brady
George...

[george]

Hi Brady

Thanks for your reply. I sent you a email, did you get it? Please let me know.
Thanks
George...

Hi Brady
Thanks for the link. Did you use ALL of the 50` tubing? Would you be willing to sell me 20` of it?
Let me know just in case I get...

[george]

Thanks Rick
I sent an email to them and will see after the long weekend if they reply.
George...

[george]

What length did you buy and can I have the contact information?
Thanks
George...

[george]

Thanks Rick!!!...

[george]

Hello
I am thinking about a non sub related small project that will work with compressed air and I have sourced ALL BUT the air line that is strong...

[george]

That is Great news! Thanks again Sir. Have a Good Time at your run next week, while here we start to feel the cold of Winter coming.

[george]

Plans have been SOLD
Thanks...

[george]

Sir your verbal replies can be worse than a physical bite!!!!
Than You for ALL your Help with this and ALL your other post / builds.

...

[george]

Hello
Yes I got the cast items: planes, rudders, saddles and intakes, metal washers. bearings, metal propeller and hull alignment cast pieces. No...

[george]

O.K then first, Thanks for the lesson.
Now here comes a possible bad question. Here I go, into the lion`s den. I received your first part of the...

[george]

Sorry another question on bow plans shafts. Is that correct that the operating shaft for the bow planes is 1/16" OR was it supposed to be 1/8"...

[george]

Not a problem thanks for clearing that up Sir

[george]

I thought the cranks were on the inside of the hull....

[george]

Thank You for the lesson. Can I ask you about the last picture above? I see two little brass rod stubs, one at each bow plan, what is their function?...

[george]

Question about Bow planes support rods. I think the norm is to use 1/8" brass here in the West. Anyone have running experience with these? I was...

[george]

Thank You also for sharing your Wisdom with us. David the Wise One!...

[george]

ouch! Tough to ask to see better, Wait till you youngsters get old and eyes act up!

[george]

Hi Scott T
Any chance you could draw that out in darker ink? Also hard to read the writing. The image is not dark enough to be seen easily for me...