Welcome to our forums. For the best in R/C submarine kits, components and accessories, be sure to visit the Nautilus Drydocks
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Have you tried asking FlaredPhoenix? He's done a number of challenging submarine subjects and is available for hire. Not sure of his fees, but might be worth a shout.
Just one final flattened clear-coat away from completion, in seconds I ruined the finish of Jake's 1/72 SKIPJACK class r/c model submarine through shear overconfidence and non-vigilance.
I rushed the job; took short cuts.
I was too enamored with past accomplishments to regard normal set-up precautions as prerequisites, not options.
I over-doped the clear-coat with flattening agent and thinner.
I set the touch-up gun with too much product flow and shot the work at too close a distance.
And I did the job late at night, a bit fatigued, and should have addressed this chore early the next morning, fresh and alert.
I have since wet-sanded away the above waterline portions of the hull and repainted it.
Back to square-one because I was an arrogant dumb-ass! Lesson re-learned (yet again!!!)
Well, look at the bright side, yesterday was a disaster, but at least you remembered to put your pants on this morning.
Not so fast, Island-Boy!! (early morning, sitting at the computer, still groggy from last nights adventure, looking down to a pair of hairy thighs) ****!
Comment