Here we go. it's designed for flyers, but you can insert a surface crystal in it and it'll work fine. this works with 35mhz (our flying band) to 40mhz (or surface band), so I'm pretty confident this will work with 72 to 75MHZ.
It's a top bit of kit, the servos are something else, as they don't use pots for feedback, they use linear hall effect sensors- no pots to wear out and or get scratchy! The servos torque isn't massive, but should suffice, especially if you use magnetic couplers.
The receiver is a 4-channel job.
Falcon Breeze Block now with DSP & Fail Safe
The Digital Signal Processing function ensures only clean signals reach the servos. If after approx. 1-2 seconds no good signals are received, the fail safe function will be activated. The Fail Safe function remembers the Tx stick positions on power up eg, throttle closed, controls neutral. Tx on first then switch on Rx. To test fail safe, throttle up , control sticks full travel, swtich off Tx, neutral controls, motor cuts.
Designed to make installation easy for micro radio controlled models - Includes 2 Falcon digital servos and the New Falcon Receiver all on one board. ONLY 4.8g complete with crystal and designed to operate between 3 and 5v. Example: 1 Li-poly cell directly connected for gliders, or through the Falcon single cell ESC for powered models. Alternatively for 2 Li-poly cells, through the 5v BEC function of an ESC. 120metres range on only a 20cm (8") Rx aerial. The aerial can be extended for greater range.
Dimensions:
length 36mm
width 24mm
height 10mm
It's a top bit of kit, the servos are something else, as they don't use pots for feedback, they use linear hall effect sensors- no pots to wear out and or get scratchy! The servos torque isn't massive, but should suffice, especially if you use magnetic couplers.
The receiver is a 4-channel job.
Falcon Breeze Block now with DSP & Fail Safe
The Digital Signal Processing function ensures only clean signals reach the servos. If after approx. 1-2 seconds no good signals are received, the fail safe function will be activated. The Fail Safe function remembers the Tx stick positions on power up eg, throttle closed, controls neutral. Tx on first then switch on Rx. To test fail safe, throttle up , control sticks full travel, swtich off Tx, neutral controls, motor cuts.
Designed to make installation easy for micro radio controlled models - Includes 2 Falcon digital servos and the New Falcon Receiver all on one board. ONLY 4.8g complete with crystal and designed to operate between 3 and 5v. Example: 1 Li-poly cell directly connected for gliders, or through the Falcon single cell ESC for powered models. Alternatively for 2 Li-poly cells, through the 5v BEC function of an ESC. 120metres range on only a 20cm (8") Rx aerial. The aerial can be extended for greater range.
Dimensions:
length 36mm
width 24mm
height 10mm
Comment