So remove the strips and screws after the epoxy resin and cloth on inside has cured?
USS 581 Blueback
Collapse
X
-
Idiot!
David
The HorribleWho is John Galt?Comment
-
DavidWho is John Galt?Comment
-
Bruce,
I have used ZAP Z-POXY two part finishing resin with light weight glass on a couple of my Byron War Bird airplane wings (in the day) and it worked very well. I have also used it on two of my 3D printed Submarines along with fiber glass to enhance the strength of the glued up sections of the hull! I am sure there are many finishing resins out there that will do the job!
Rob
"Firemen can stand the heat"Comment
-
The Safety Float Valve Battery Chamber Manifold broke off, I am using the Snort System so how should I reattach manifold, or should I just seal the hole, either way should I use epoxy? I had allready plugged the tube from the safety float valve to the manifold with a rod.Comment
-
The Safety Float Valve Battery Chamber Manifold broke off, I am using the Snort System so how should I reattach manifold, or should I just seal the hole, either way should I use epoxy? I had allready plugged the tube from the safety float valve to the manifold with a rod.
Blank off the hole where the manifold broke off (CA and baking soda).
Blank off the internal nipple of the 4-point manifold where the safety float-valve made up to it. Run the hose from the snorkel straight into the suction side of the motor bulkhead. Now you're in Snort mode. Done.Who is John Galt?Comment
-
Comment
-
Comment