I finally made the decision as to how the 2.5" WTC will be set up for the SM UC 5 U-BOAT!
The photo show what the stern section on my SM UC 5 U-Boot looks like with 3 bladed prop.
This photo shows the components that will go into my WTC.
Transmitter: VEX FM 6 channel.
Receiver: 6 Channel FM
Motor: 900KV Brushless in the wet with 27mm 3 Bladed Resin Prop.
Receiver: Bi-directional 40A ESC.
Rudder/ Dive Plane Control: 2- Hitec HS 82 MG Servos.
On/Off Control: Heavy Duty Remote System.
Power System: Venom 4000 20C 11.1 3 Cell Lipo Battery.
All WTC internal structural parts will be 3D printed.
The set up that I am building for the SM UC 5 is mostly for surface running and possible Dynamic Diving.
Rob
"Firemen can stand the heat"
The photo show what the stern section on my SM UC 5 U-Boot looks like with 3 bladed prop.
This photo shows the components that will go into my WTC.
Transmitter: VEX FM 6 channel.
Receiver: 6 Channel FM
Motor: 900KV Brushless in the wet with 27mm 3 Bladed Resin Prop.
Receiver: Bi-directional 40A ESC.
Rudder/ Dive Plane Control: 2- Hitec HS 82 MG Servos.
On/Off Control: Heavy Duty Remote System.
Power System: Venom 4000 20C 11.1 3 Cell Lipo Battery.
All WTC internal structural parts will be 3D printed.
The set up that I am building for the SM UC 5 is mostly for surface running and possible Dynamic Diving.
Rob
"Firemen can stand the heat"
Comment