Welcome to our forums. For the best in R/C submarine kits, components and accessories, be sure to visit the Nautilus Drydocks
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Today's work on the little Revell SKIPJACK fittings kit
Got it, Garry. I'll look it over today (spent the last week fixing our hot-water heater -- all that soldering at work finally pays off!). I'll prepare your CARE package -- will also fix you up with some RenShape end-cuts, you Bum.
No big hurry, M! I know you have more than your fair share of things on your plate!
Just wanted to make sure it got to you!
Also, a couple small chunks of Ren will be most appreciated!!
I had a problem trying to justify a whole board of the stuff so I could mold up some
machined patterns for use in my eventual Kilo build!! Gonna try my hand at a
"home-stomped" WTC for her! Want to cast my own end caps, etc.!!
Have a good one, and, once again, many thanks for being there!!
Your new motor bulkheads (actually two, one of them is a very 'hot' wound motor, so marked on the body of the thing), RenShape end-cuts and some other crap went your way yesterday, Gary.
Comment