Welcome to our forums. For the best in R/C submarine kits, components and accessories, be sure to visit the Nautilus Drydocks
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hooked up all my linkage everything worked except for my retrat. Will not rotate enough to raise or lower the retracts. Not enough room to put a longer servo arm on. This is on my gato. any ideas?
Frank
hooked up all my linkage everything worked except for my retrat. Will not rotate enough to raise or lower the retracts. Not enough room to put a longer servo arm on. This is on my gato. any ideas?
Frank
Do they deploy/retract fully with the upper hull off the lower hull?
Cut away the aluminum tray under the retract servo. Drop the retract servo till the output arm (bell-crank) is at the cylinders maximum diameter. Install a longer bell-crank arm. Send me money. Sing my praises! Register me as a religion!
That fixed the problem. I'm happy til the next fix. Going to test wtc in water wedsday, hopfull there will be no leaks. Again thank you for your help
My pleasure, sir.
For the in-water test, pull the tire-valve core, put a flexible hose to its body so you can blow air into the SD. Hold a hand at each end so you don't pop a bulkhead off the cylinder, blow into the hose and dunk the SD into the drink. You're looking for bubbles!
Comment