Bringing my first boat to life again

[JHapprich]

November overkill, Vol.1:

[JHapprich]

November overkill, Vol.2 :

[JHapprich]

And Vol. 3 :

[JHapprich]

And finally Vol. 4 :

[JHapprich]

Last post also showing the 645'/ K 27 subclass with liquid-metal coolant reactor.

[He Who Shall Not Be Named]

And finally Vol. 4 :

Wow! such a magnificent series of NOVEMBER photos. I so want to do this beast someday! Thank you for sharing this excellent information on such a historically (and politically) important Cold War submarine.

[JHapprich]

Fin's attached!

[JHapprich]

Hello! Recently made a new stern insert( that knife-form thing covering the driveshaft) to replace the very heavy original ABS piece.



I decided to maintain the method of using two transversal bolts to secure the aluminum stern frame to the mount inside the stern cone (you'll see that in the pictures).



In the first place, i only applied ABS sheet to that original part and bolted it down with six M2 sunk screws, but that both looked not nice and did not give me more space between propeller and rudder what is a priority...






I cut the old grp-cover from my first attempt of remaking the stern to lenght and used it as a base to build up the sides.



The fillets of the stern planes,made from cast PU, were laminated into those sides after aligning and pinning with CA. An M2 bolt from each side, aft of the planes shaft through the fillets, secures the new stern insert to the stern frame and keeps it detachable.



The sides were then built up with fibre-enhanced filler. After grinding it to shape, a layer of light weave and fine-filler will produce a smooth surface. The entire replacement will be MUCH lighter than its ABS-predecessor!

As said, i drilled both sides of the stern above the sockets of the stern frame, afterwards screwed a threaded rod through it and wrapped some sandpaper atound it to grind the bore to a nice round shape with the socket bore right in center. That was the original method of securing the aluminum stern and allows that whole module to be removed for maintenance. However, the openings for the screws are WAY smaller and will be alike larger floodholes..

[He Who Shall Not Be Named]

You have put a great deal of hard, 'innovative' work into this project. You, sir, are a plodder... and I mean that in the most positive sense of the word.

You get your hands dirty. I admire that.

You and I would be equally comfortable slipping and sliding along the floor of a sausage factory.

David
Expert Plodder