Home
Collapse
-
Yes, you are absolutely right, however i have decided to make it that way, as i will have very very very little freeboard. Afterall, it is not scale,...
Last edited by JHapprich; 11-14-2026, 02:30 AM. -
Scratch-CADed then?
I wonder if there are any x-craft kits suiteable for those little toy subs ;-)Leave a comment:
-
Some drybrushing with Revell enamel paint later. Sand brown, flat white, gunmetal, silver.I am going to spray it over with clear coat tomorrow.
...Leave a comment:
-
Mixed up some "mudd" for the lower hull. I hope to achieve that waterline with the small balast tank.
Jörg...Leave a comment:
-
More painting. Sanding upper hull with 1200 grit, flat white dry brushed, another layer of dark grey. ...
Leave a comment:
-
This evening, i did some basic painting. Mixted silver grey with flat black, added thinner. Found out i had no brass color for the prop, so enamel silver...
Leave a comment:
-
Haven't had much hobbytime lately, but filled all the missing spots at the stern, the fillets for the diveplanes and made a hook-and-bar to close the...
Last edited by JHapprich; 11-10-2026, 04:33 PM.Leave a comment:
-
-
This reminds me of a dental technicians workshop! Always fun to have molten metal flying around! Mr.Merriman, how are your arm's doing? Hopefully, only...Leave a comment:
-
-
Albacore, i am a bit confused about the picture of my 665' Whiskey's bow plane mechanism. So you are going to copy the technique? You need more pictures...Leave a comment:
-
Question:
Those stern tubes, were there any streamlining covers involved?
i mean, compared to the contemporary NOVEMBER, this looks...Leave a comment:
-
I used a lot of "plastic soldering" on that model, e.g. load bearing parts were drilled through and pinned together using plastic rods. With...
Last edited by JHapprich; 10-31-2026, 05:41 PM.Leave a comment:
-
The two white tubes in the stern end are the "wave-tunnels" for the stern thrusters. They were made grom 1mm ABS sheet, wound around a round...
Leave a comment:
-
I skipped the brass propeller as it was inefficient. I figured the small motor could handle a much larger prop and used an 3-bladed (and VERY old) plastic...
Last edited by JHapprich; 11-01-2026, 05:20 AM.Leave a comment:
-
The cable wires of the toy were extended and the hull perforations sealed with RTV. Due to leaking caising damage to the receiver board, i had to buy...
Leave a comment:
-
The hull-halves are joined by indexing lips, a stainless locking bolt screws through two corresponding blocks into a M2.5 brass nut:
...Leave a comment:
-
Update. Since my last post i completed most of the model, with some scribing left and of course painting it. I made a holding fixture for the toy sub's...
Last edited by JHapprich; 11-01-2026, 05:17 AM.Leave a comment:
-
I just watched your video and am deeply impressed! Well done, especially with minimum requirement of tools to put things together!
JörgLeave a comment:
No activity results to display
Show More
Leave a comment: