Got this baot from Bob at the Dry Docks. This is the replacement for my 66 inch model Steve now has. I got to say this is a little jewel. Although have have built many of these for customers this time I'm using a subdriver and following Bob's videos which are a huge help in improving the operation of this boat over anything I have done with this model in the past.
I made a lot of progress in the short time I had yesterday at the studio. I have so much costumer work to do and orders to fill it's hard to find the time but I need my basket weaving at the end of the day!
I got the stern cut done, the prop pitch mechanism in place, the key and ram hold downs in. In addition to all that Bob's 3D printed WTC mounts were a huge help for keying the cylinder in place.
Thanks to Steve I got my rust kit in the mail yesterday. Thanks Steve for turning me on to these.
Lots to do still but I'm enjoying this build. These drive well in the wet no matter what the size.
I made a lot of progress in the short time I had yesterday at the studio. I have so much costumer work to do and orders to fill it's hard to find the time but I need my basket weaving at the end of the day!
I got the stern cut done, the prop pitch mechanism in place, the key and ram hold downs in. In addition to all that Bob's 3D printed WTC mounts were a huge help for keying the cylinder in place.
Thanks to Steve I got my rust kit in the mail yesterday. Thanks Steve for turning me on to these.
Lots to do still but I'm enjoying this build. These drive well in the wet no matter what the size.
Comment