I think this would have done the job to get my boiler suit clean after cleaning the scavenging...
Search Result
Collapse
500 results in 0.0430 seconds.
Keywords
Members
Tags
-
According AI this is the laundry o/b a WWII sub.
I think this would have done the job to get my boiler suit clean after cleaning the scavenging...Last edited by bwi 971; 07-23-2024, 06:56 PM. -
The leaking of water through the pump is called backflow and is normal for pumps other than peristaltic pumps . I don't know what type of pump they are...
Last edited by bwi 971; 07-23-2024, 05:50 PM.Leave a comment:
-
Maybe think about a twin hull design catamaran.....I built the scale RC demonstrator model for a client of a twin hull (the 1/1 scale was was designed...
Leave a comment:
-
Is that a coffin for the model-making craft?
grtz,
Bart, the poking SOB!...Leave a comment:
-
Worked on the ballast tank.
The ballast tank was placed at the correct location in the hull, and measurements were taken for the appendages,...Leave a comment:
-
Yes it is, first time I read about them was in Norberts book Technik der U-Boot-Modelle, wonder
full.
Grtz,
bart...Leave a comment:
-
As the ballast tk priciple is working I make a new one with all the protusions at the right positions (Ballast pipes, P/V valves, breather pipe). When...
Leave a comment:
-
I designed a housing for the P/V valves to conform with the other ballast tank appendages. The P/V valve will be pinched between an upper and lower housing,...
👍 2Leave a comment:
-
cherry poped...the WTC was tested.
Filling the Ballast Tank:
The gear pump fills the ballast tank with water. Air escapes through a...👍 3Leave a comment:
-
Thinned the air dry putty to paint it on and then sand it down?
Grtz,
Bart...Leave a comment:
-
I had to add the footholds at the bottom. First, they were scribed with an old stencil of the Akula.
...Leave a comment:
-
as long as its position is higher than the watersurface when the boat is sufaced it will be ok, but I like to have some additional head so I maximised...👍 1Leave a comment:
-
so is this...I hope they can tackle all the flaws....it will break open the SLS consumer market.
https://www.micronics3d.com/...Leave a comment:
-
Various Progress
I reprinted all parts with the new resin as it withstands water.
Servo Linkages
...Leave a comment:
-
I had a new insight regarding 3D resin.
The pump was left with water inside, and a few days later, I tried to turn it, but it was seized....Leave a comment:
Leave a comment: