help build a water seal drive shaft

[aliyesami]

I am following this video to build a water seal drive shaft https://www.youtube.com/watch?v=sjuMFJOgMJU
but i can't find the parts , i went to the Precision associate website but there they have other companies listed and not the parts themselves.
also the author is not mentioning the ID/OD of the bushes .
I need the ID/OD of hollow tube , flange bush the cup seal and the drive shaft dia and if possible one shop where i can buy all these .

any help greatly appreciated
Sami

[trout]

Your timing is great...... I believe Bob has just started to make complete setups of the seals - check out https://www.rc-submarine.com/props-bearings-seals

[He Who Shall Not Be Named]

I am following this video to build a water seal drive shaft https://www.youtube.com/watch?v=sjuMFJOgMJU
but i can't find the parts , i went to the Precision associate website but there they have other companies listed and not the parts themselves.
also the author is not mentioning the ID/OD of the bushes .
I need the ID/OD of hollow tube , flange bush the cup seal and the drive shaft dia and if possible one shop where i can buy all these .

any help greatly appreciated
Sami

Try the McMaster-Carr catalog. That's were I get most of my stuff.

David

[aliyesami]

hi David
i can look at McMaster-Carr but i need the ID ODs of the parts involved , can you give it to me for a 1/8 inch dia shaft assembly ? so the ID ODs of bush, tube and C cup seal ?

[rwtdiver]

Your timing is great...... I believe Bob has just started to make complete setups of the seals - check out https://www.rc-submarine.com/props-bearings-seals

aliyesami,

As per Tom! I also would suggest going to Nautilus Drydocks for these parts! I use his on all my projects!!

Rob
"Firemen can stand the heat"

[aliyesami]

aliyesami,

As per Tom! I also would suggest going to Nautilus Drydocks for these parts! I use his on all my projects!!

Rob
"Firemen can stand the heat"

hi Rob
can you give me the measurements oif the bush, tube and cup seal please ? i am confused on how to select these based on Bob's video . e.g if the tube inside dia is 1/8 inch then the bushing OD should be little less than that right?
so if you can give me these three parts from them with the part number i will be grateful

[RCSubGuy]

1/8” used 9/32 brass tube, 1/8” oiliness bushing and 1/8” seal