Home
Collapse
-
Ok! What is the preferred assignment of servos? From left to right, looking at the shaft coupling sticking out of the end-cap. I originally was gonna... -
Quad-ring (4 lobes). Very good sealing properties when used with pushrods. Keep it lubed up and it will give many hours of sealage enjoyment!Leave a comment:
-
Servos are ordered up. Meanwhile, I'm doing stuff to further progress. Throwing paint around, test fitting bits and pieces, researching sail mods, etc....Leave a comment:
-
Thank You! I'll check the fit dimensionally and proceed from there. :)Leave a comment:
-
1/72 Gato 2.5" Sub Driver; Recommended Servos?
I am engaged in building a 1/72 Gato. I had installed some servos that nicely fit the tray fore & aft, side to side. They're too frickin' tall!!... -
Got it! Appreciate the explanation, and I understand from the years of worshiping the NSTM!!Leave a comment:
-
HWSNBN,
I got to wondering yesterday about the possible need to replace some o-rings in the future, so, I thought I would ask if you would...Leave a comment:
-
Thank you, sir. I shall enough it then and consult with you this weekend. See you Friday! Safe traveling,
BillLeave a comment:
-
An old crack reawakens! There's an existing crack across the bottom bulkhead bolt hole, running from the MBT flood port and extending aft into the engineroom...Leave a comment:
-
I'll eyeball the cylinder today. I recognize the cracks in the pictures! :) That's my 2.5" cylinder. Tub trials will continue today. Yes, it...Leave a comment:
-
3.5" Cylinder Assist
I am getting close on getting my 1/72 Skipjack trimmed. Standard process; submerge, try stuff, pull apart, glue in foam/weight, repeat. Each session,... -
Use a Magnetic Mission Switch!!! Get away from the over-sized, bulky and parasitic remote goober thing!!!!! :)Leave a comment:
No activity results to display
Show More
Leave a comment: