stl files

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • biggsgolf
    Captain
    • Jan 2020
    • 720

    stl files

    Magnet Lanyard for Magnetic On/Off Switch

    Last edited by biggsgolf; 03-29-2021, 05:19 AM.
  • coryhenry
    Lieutenant Commander
    • Jul 2020
    • 156

    #2
    Are you looking for files?

    Comment

    • biggsgolf
      Captain
      • Jan 2020
      • 720

      #3
      No, was going to share an stl file, did not know we are not allowed too. can't figure out how to delete this post...

      Comment

      • coryhenry
        Lieutenant Commander
        • Jul 2020
        • 156

        #4
        I didn't know we couldn't share stl's. Where did you get that? Subcommittee has a place to share.

        Comment

        • biggsgolf
          Captain
          • Jan 2020
          • 720

          #5
          When you attempt to upload an stl file it says not allowed, it’s a shame unless someone were to upload a conflict of interest file

          Comment

          • trout
            Admiral
            • Jul 2011
            • 3545

            #6
            Maybe try zipping the file and uploading a compressed file. It may not allow a sty file, but a .zip file may be fine.
            If you can cut, drill, saw, hit things and swear a lot, you're well on the way to building a working model sub.

            Comment

            • biggsgolf
              Captain
              • Jan 2020
              • 720

              #7
              Was looking to share my stl files, I will look at subcommittee to share, thx

              Comment

              • biggsgolf
                Captain
                • Jan 2020
                • 720

                #8
                Do you have a link to that Subcommittee stl sharing forum?

                Comment

                • trout
                  Admiral
                  • Jul 2011
                  • 3545

                  #9
                  It is under members > vault
                  It requires it to be zipped as well.
                  If you can cut, drill, saw, hit things and swear a lot, you're well on the way to building a working model sub.

                  Comment

                  • biggsgolf
                    Captain
                    • Jan 2020
                    • 720

                    #10
                    Ok, Thanks

                    Comment

                    Working...