Announcement

Collapse

Forum rules and expectations

Hello, and welcome to the forums at the Nautilus Drydocks, formerly Sub-driver.com!

We welcome anyone with a passion for submarines and a desire to learn and share knowledge about this fascinating hobby. Use of these forums indicates your intention to abide by our code of conduct:


1. No spam. All automated messages, advertisements, and links to competitor websites will be deleted immediately.

2. Please post in relevant sub-forums only. Messages posted in the wrong topic area will be removed and placed in the correct sub-forum by moderators.

3. Respect other users. No flaming or abusing fellow forum members. Users who continue to post inflammatory, abusive comments will be deleted from the forum after or without a warning.

4. No threats or harassment of other users will be tolerated. Any instance of threatening or harassing behavior is grounds for deletion from the forums.

5. No profanity or pornography is allowed. Posts containing adult material will be deleted.

6. No re-posting of copyrighted materials or other illegal content is allowed. Any posts containing illegal content or copyrighted materials will be deleted.
See more
See less

stl files

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • stl files

    Magnet Lanyard for Magnetic On/Off Switch

    Last edited by biggsgolf; 03-29-2021, 05:19 AM.

  • #2
    Are you looking for files?

    Comment


    • #3
      No, was going to share an stl file, did not know we are not allowed too. can't figure out how to delete this post...

      Comment


      • #4
        I didn't know we couldn't share stl's. Where did you get that? Subcommittee has a place to share.

        Comment


        • #5
          When you attempt to upload an stl file it says not allowed, it’s a shame unless someone were to upload a conflict of interest file

          Comment


          • #6
            Maybe try zipping the file and uploading a compressed file. It may not allow a sty file, but a .zip file may be fine.
            If you can cut, drill, saw, hit things and swear a lot, you're well on the way to building a working model sub.

            Comment


            • #7
              Was looking to share my stl files, I will look at subcommittee to share, thx

              Comment


              • #8
                Do you have a link to that Subcommittee stl sharing forum?

                Comment


                • #9
                  It is under members > vault
                  It requires it to be zipped as well.
                  If you can cut, drill, saw, hit things and swear a lot, you're well on the way to building a working model sub.

                  Comment


                  • #10
                    Ok, Thanks

                    Comment

                    Working...
                    X