David Merriman's Garage Sale

[Kazzer]

SOLD





Here is the Sub-driver. It needs 3 servos.

[subkraft]

Yes please.
A couple of questions
-can you post a pic of the actual 11" subdriver so I know exactly what you're sending - or is it the one shown previously
- the 3.5 inch endcap....will need seals as well, yes?

Thanks..

[Kazzer]

SOLD

So $205 for both plus air post to Australia. If you can let me know the total I organise by paypal?

Thanks, Regards

This and the 11" Sub-driver?

[subkraft]

$150 and they are assembled.

So $205 for both plus air post to Australia. If you can let me know the total I organise by paypal?

Thanks, Regards

[greenman407]

So what do you say there Mike? Got anything for me?

[He Who Shall Not Be Named]

More torpedo development today, Boss. I'll gather his stuff up over the weekend. Kailagh just hit me with a PO.

M

[Kazzer]

frightening!

M

Get back to work. Slats needs his stuff!

[He Who Shall Not Be Named]

[ATTACH=CONFIG]24201[/ATTACH]
One of these with all the levers and valve etc?

frightening!

M

[greenman407]

Mike, Nice picture. All I need is the gas valve, that goes in the middle slot. However, if it all comes together, maybe I can use the other stuff in the future.

[Kazzer]

Mike, I need a gas valve to fit my new SAS. Looking at my other cylinders, I would say that a gas valve from a 3" cylinder will work. What do you have there? Perhaps a gas bulkhead for a 3" cylinder? Or perhaps , if need be a full cylinder? At anyrate I want to rob a gas valve from it. Let me know. Thanks

One of these with all the levers and valve etc?

[greenman407]

Mike, I need a gas valve to fit my new SAS. Looking at my other cylinders, I would say that a gas valve from a 3" cylinder will work. What do you have there? Perhaps a gas bulkhead for a 3" cylinder? Or perhaps , if need be a full cylinder? At anyrate I want to rob a gas valve from it. Let me know. Thanks

[Kazzer]

Thanks...that will be great.
What price is on the small 11 inch long drivers?

$150 and they are assembled.

[subkraft]

Thanks...that will be great.
What price is on the small 11 inch long drivers?

The adjustment of the ballast tank is like this:

Wind the bulkhead in and out. I grabbed it thinking that it could be a good way of establishing the right size for a tank by trial and error.

[Kazzer]

[ATTACH=CONFIG]24168[/ATTACH]This is the 3.5 inch subdriver.....need motor unit, endcap, single screw. Guess it's fairly old but has cool adjustable volume ballast tank. Thanks for looking.

How did HWSNBN do the adjustment of the ballast tank?

[Kazzer]

Here's what I have, a complete Motor Bulkhead and tray with new seals and a Groupner 550 7.2 volt motor. Spare screws included for the tray.
$55