Oh, Great and Exalted Wizard of the Deepness,
While wrestling with some electronic issues, my B&V servo hyperextended itself to 90 degrees toward vent position and the pushrod disconnected itself from the servo arm via the slot in the arm. Is there some method to get it re-connected short of fully disassembling the cylinder and pulling the servo off the bulkhead? So far, my fiddling about, swearing under my breath, and holding my lips in certain positions is not working!!
A. Flangehead
While wrestling with some electronic issues, my B&V servo hyperextended itself to 90 degrees toward vent position and the pushrod disconnected itself from the servo arm via the slot in the arm. Is there some method to get it re-connected short of fully disassembling the cylinder and pulling the servo off the bulkhead? So far, my fiddling about, swearing under my breath, and holding my lips in certain positions is not working!!
A. Flangehead
Comment