Welcome to our forums. For the best in R/C submarine kits, components and accessories, be sure to visit the Nautilus Drydocks
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi David. I used to lay it out in narrow bars on waxed paper until it hardened. I could break off pieces and add small pieces in areas of the hull where needed. Not nearly as clean as your method, but I didn’t have to cook anything in the kitchen to mold them. I like the idea of wheel weights like Rob is showing too.
I use the wheel weights for trimming too but they do rust pretty quickly. The foam tape on them is not very reliable so I usually peel it off and use Goop to hold them in place.
Comment