Making stuff

[Lockleer1]

I learned an incredible amount from looking at pictures posted just in the last 6-7 months and I think it's very refreshing to see what someone is up to in their shop each day that they post about a project. In keeping with that idea of "Today's work" I'm going to start posting pictures of what I do in my shop when I can though as a warning, it probably won't be daily. Enjoy and if explanation is needed I'll answer the best I can.

[He Who Shall Not Be Named]

I learned an incredible amount from looking at pictures posted just in the last 6-7 months and I think it's very refreshing to see what someone is up to in their shop each day that they post about a project. In keeping with that idea of "Today's work" I'm going to start posting pictures of what I do in my shop when I can though as a warning, it probably won't be daily. Enjoy and if explanation is needed I'll answer the best I can.

Looking forward to it. I can learn stuff as well.

[Lockleer1]

Driver for a 1/144 Typhoon. My first twin screw and first one I did with servos in the forward bulkhead.

[Lockleer1]

1/144 Typhoon driver

[Lockleer1]

1/144 Typhoon driver, more pictures

[Lockleer1]

1/144 Typhoon driver, lots more pictures

[Lockleer1]

1/144 Typhoon driver done! I built this for a buddy, Never has he been involved with subs so I recommended a dynamic boat first. Maybe change it to a ballast system later once I finalize my design.

[Lockleer1]

When I got my Blueback, the bull gear in the driver had 4 teeth a little worse for wear so I had to replace it. Just so happens that I know how to make gears so I got a piece of 1” delrin and made one. Then I found out through reading on the forum not long ago that a buddy needed some of the same gears so I decided to make a few more. Anywho, here are some pictures of the process.

[He Who Shall Not Be Named]

When I got my Blueback, the bull gear in the driver had 4 teeth a little worse for wear so I had to replace it. Just so happens that I know how to make gears so I got a piece of 1” delrin and made one. Then I found out through reading on the forum not long ago that a buddy needed some of the same gears so I decided to make a few more. Anywho, here are some pictures of the process.

... and your buddy is most appreciative, Louis!