Ok, I saw the tiny skip at the regatta, and decided that I have to have one in the suitcase (cigar box) to take with me on vacation to places like Disney, etc... I could get away with having it because it is so small. Heck, I could sit on the can and play with it (the sub) in the tub...
So, I got the Micro ESC, and there are no wires attached to it. I have looked at the documentation, and cannot figure out which of the 4 solder pads are for what> I really don't want to fry this thing.
Any ideas, if I am looking a it, with the button facing up, and the Rx wires facing to the right, the four pads are along the left edge of the esc. from top to bottom, so...... um..... which is which?
Secondly, I was hoping to get some measurements from Dave. About where (after screeding the bow) did you make the cut on the lower hull to capture the WTC? I am assuming that this line is not super critical, but I would like some advice.
Thirdly, and sorry for the questions.... But after laying the sub on Greg's plan, I figure that I am just going to cut the stern along one of the "weld lines" that pretty closely match the shape, am I correct?
Sorry for all of these questions at such a late hour.....
Well, I've got tests to grade and planning to do for tomorrow...
otherdave
So, I got the Micro ESC, and there are no wires attached to it. I have looked at the documentation, and cannot figure out which of the 4 solder pads are for what> I really don't want to fry this thing.
Any ideas, if I am looking a it, with the button facing up, and the Rx wires facing to the right, the four pads are along the left edge of the esc. from top to bottom, so...... um..... which is which?
Secondly, I was hoping to get some measurements from Dave. About where (after screeding the bow) did you make the cut on the lower hull to capture the WTC? I am assuming that this line is not super critical, but I would like some advice.
Thirdly, and sorry for the questions.... But after laying the sub on Greg's plan, I figure that I am just going to cut the stern along one of the "weld lines" that pretty closely match the shape, am I correct?
Sorry for all of these questions at such a late hour.....
Well, I've got tests to grade and planning to do for tomorrow...
otherdave
Comment