Welcome to our forums. For the best in R/C submarine kits, components and accessories, be sure to visit the Nautilus Drydocks
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Renshape is just polyurethane tooling board. You can't get it in the UK under that brand name either, but there is exactly the same stuff available under different brands, and it varies from country to country.
It's available in different densities.
Here in the UK, Easy composites sell it in small blocks.
Easy composites manufacture and supply materials, equipment and consumables for advanced composites including reinforcements, prepregs, resins, vacuum equipment, ovens and much more. We offer next-day shipping within the UK, fast shipping word-wide and free expert technical advice on all products.
Usually you have to but it in large sheets, which is expensive, unless you are a pattern making fiend. e.g.
If there are a group of you that can chip in and saw it up into smaller chunks, then it works out very cost effective.
I tried that approach a few years back but only two or three people expressed an interest- I can count scratch-builders in this hobby on one hand with missing digits,.
I make my patterns from wood, metals and plastic. Finishing takes a little longer, but the materials are easy to source and often free (salvage).
No its not. Its actually LK950004490AU or LK950016949AU. Impossible for me to tell which of the two is yours however. Australia Post - bringing you yesterday's solutions, tomorrow (if you're lucky).
Speedy little thing, and damned good depth-control on display there. I've re-thunk the motor bulkhead for your ZULU SD, will get on that today -- sorry about the delay.
Comment