Slowly building up my Skipjack. Despite having the hull halves tight together and allowed them plenty of time to cure, on releasing them ive found a big warp. Once i bond the lower bow section on, i believe i can create a closure which will pull the hull together, but concerned that long term the force will cause more problems. Should i cut through one of the hull joins (lower hull) and remake the joint so that its tight at the bow? Or maybe some heat on the hull to try and relieve the hull?
Skipjack, yet another
Collapse
X
-
Albion, it's kinda hard to see the picture is so small. Are you using the "z" cut on your hull? Do you still have the indexing pins in place? Personally I think that I would just put a screw thru from the top into a bracket above the Subdriver and pull the hull downIT TAKES GREAT INTELLIGENCE TO FAKE SUCH STUPIDITY! -
Last edited by Albion; 10-06-2016, 01:33 AM.Next time someone points out it takes 42 muscles to frown, point out it will only take 4 muscles to b1tch slap them if they tell you how mnay muscles you need to smile:popComment
-
not sure why they are tiny, i guess i need to dig out the good camera5 PhotosNext time someone points out it takes 42 muscles to frown, point out it will only take 4 muscles to b1tch slap them if they tell you how mnay muscles you need to smile:popComment
-
I did, and checked large. Let me try using a camera rather than phone and see how those images lookNext time someone points out it takes 42 muscles to frown, point out it will only take 4 muscles to b1tch slap them if they tell you how mnay muscles you need to smile:popComment
-
I don't think I would worry about long term stress on that plastic. It'll be fine. As far as pictures go, both my Fuji digital cameras take pictures in the 3800 to 4000 range. They used to post fine. Lately I get a message from the caswell site that my pictures are too big. When they do post, they post small. I have been using "Picasso" to resize them Down to 1600 and it's been working OKIT TAKES GREAT INTELLIGENCE TO FAKE SUCH STUPIDITY!Comment
-
-
in post reply, i click on the paperclip, then , upload attachments, select a file, then click fullsize, then post replyNext time someone points out it takes 42 muscles to frown, point out it will only take 4 muscles to b1tch slap them if they tell you how mnay muscles you need to smile:popComment
-
Had a look in detail at the hull seem and spotted that it's actually my alignment tabs which are causing the problem, carefully cut away at the channel in the hull join, if you have his kit you know what I mean, and whilst it isn't 100%, it only takes a small force to hold hull together. Now need to make a latch .Next time someone points out it takes 42 muscles to frown, point out it will only take 4 muscles to b1tch slap them if they tell you how mnay muscles you need to smile:popComment
-
Last edited by Albion; 10-11-2016, 10:20 PM.Next time someone points out it takes 42 muscles to frown, point out it will only take 4 muscles to b1tch slap them if they tell you how mnay muscles you need to smile:popComment
Comment