wTc ideas !

[Scott T]

You got a Bingo!

[Scott T]

So I see you milling out the inside portion of the end-cap/ballast tank and
wondered if it would be less labor intensive to cut, glue then turn/mill...

[Scott T]

Question on renshape. Is a super glued joint strong enough to turn? If yes could you then cut the cylinder with a bandsaw then glue it to a solid renshape...

[Scott T]

Thanks Bob and crew....

[Scott T]

Yeah I got these pictures to load. Hope anyone finds these useful.

[Scott T]

Side views ...

[Scott T]

3in Wtc idea uses same motor compartment end cap as 2.5in wtc

...

[Scott T]

2.5in wtc idea
...

[Scott T]

Some ideas for a modular WTC. Pictures show a 2.5in & 3in ballast tube.
1. The adapter rings are sealed at the flat joints both ends with electrical...

[Scott T]

Could the web master take a look and see why I cannot upload jpg or png files.
Error uploading images. I even tried a file I had uploaded before...

[Scott T]

http://subcommittee.com/forum/attach...369026&thumb=1
Posted very bad sketch at Sub Comm. copy paste the link...

[Scott T]

Thanks Tom! You are very quick with that sketch up!
Another way to get rid of the air bubble is to have the casting slide over the outside of the...

[Scott T]

Well I can't get this drawing to upload. But I sent an email to Tom just now to see if he can upload it.
My sketch has the same problem with the...

[Scott T]

David,
If you made the vent hole part of your casting you might be able to remove the ballast tube without fiddling with the vent.
This would...