Hey Mike Looking for A Used WTC From Your Special Bin

[george]

Hi Mike

Do you have a WTC from D.M that is the Standard 1/96 Sub Driver, 2.5" dia., 20.25" long. I don`t need the copper propel tank and it`s parts. I would like to have a Fully equipped Engine room OR near to it. I still want the ballast tank and battery section to make up the 20.25" long WTC. If not fully equipped engine room, as long as the seals and 3:1 motor drive is in it and servo tray, I have servos, the other electronics would be nice and maybe long duration battery.

Do you have one and how much? Pictures would be nice also.

Thanks Mike

George

[Kazzer]

Those measurements are very specific. What boat is this for? Single engine? What sort of ballast system are you thinking of?

So you want all the electronics too? You'll need to buy an electronics kit for that as I'm not selling those components off cheaply. (No second hand parts available)

I have a 21" x 2.5" tube, and can probably rig it once I have a bit more info.

Thanks

[george]

Hello Again Mike

Thanks for your reply. The WTC is for my Darnell X-Craft, Single drive. If there is NO electronics, I`m o.k with that, still would like the main motor and ALL seals in it as for the ballast tank. I wish to use the one you don`t care for, the air bladder system, using the WTC internal air for it.

Hope that gives you the info. you need. I MOST likely am forgetting something, please ask away.

Thanks Mike

George

[Kazzer]

OK! The 2.5" cylinders have 280 motors in them usually, and I'd suggest you need something larger, so go to a 3" cylinder. That sub is a log in the water.

All I have is this unit which fits in the Darnell X perfectly. It has a gas ballast system, 400 groupner 7.2 volt motor, 2 servos (standard), gas saver system and battery compartment, large Subtech Speed controller, large air pump, battery connector.

All this needs is a pitch controller and batteries.

$160 will cover it all, including ship to Buffalo.

Mike