Viper reverse question

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Capt. Don
    Ensign
    • Jan 2009
    • 5

    Viper reverse question

    I have the Viper10 and the WFLY 06A with 75.57 crystals. I can't get the Viper to go into reverse. I have tried the setup many times. The servo's work. I have the viper inserted into ch 3 and it will control the speed but not go into reverse. The WFLY doesn't say it works with 75MHz.
  • Subculture
    Admiral
    • Feb 2009
    • 2119

    #2
    Try the servo in port/channel 3, if it works each way, the problem lies with the ESC. Crystals don't make any difference to the function of an ESC, BTW.

    Comment

    • Kazzer
      *********
      • Aug 2008
      • 2848

      #3
      I had this problem. The answer is in the instructions.

      Download them here

      Look at page two. There is a flow diagram and you need to set the 'reversible set' to position #4, which gives you instant reversal, with no delay.
      Stop messing about - just get a Sub-driver!

      Comment

      • Capt. Don
        Ensign
        • Jan 2009
        • 5

        #4
        Viper is working in Rev.

        I got the Viper to go into reverse yesterday. I removed the motor during the setup and set it for no lag between forward and reverse.

        Comment

        • mtroniks
          Lieutenant, Junior Grade
          • Apr 2009
          • 12

          #5
          Hi. Yes, there is a 'reverse-off' function in the setup - can be inadvertantly actuated whilst setting up radio functions. See instructions, can be re-enabled! Steve.

          Comment

          Working...