Snort pump control pcb

[oztruck]

My mini snort control has stopped working. All was good and worked well, then I did a water test and a small amount of water found its way into the WTC. it must have found its way onto the board because it doesn't work any more.

I have checked and dried everything but still no go. /any suggestions?

Cheers Chris




This is KMCDesigns product. I moved the post - hopefully KMC will see it.

Moderator

[KevinMc]

Hi Crhis,

Does the LED still turn on and off as you toggle the switch on your transmitter, or is that dead too?

Regardless, I could likely repair it but to do that you'd have to send it to me. (You could however leave the pump attached and just de-solder your power connection at the most convenient location.)

Check your LED and we'll PM to get you sorted out.

[He Who Shall Not Be Named]

Now, that's service!

[oztruck]

XLNT service