Kevin,
When I start the setup procedure for pitch control on my ADFc2 I follow these steps: 1) Press & hold setup button, 2) Turn on RX, 3) Status light blinks red then goes solid green, 4) Release setup button and the light stays solid green and stays green. This is as far as I've been able to go on the setup procedure no matter how many times I try to start over from the beginning. Without the ADFc2 plugged into the RX the motor, rudder, planes, ballast vent, and pump for blowing ballast work normally. When I plug the ADFc2 into the RX, everything works normally except the planes. What can you suggest please?
SSBN659
"Will" Rogers
When I start the setup procedure for pitch control on my ADFc2 I follow these steps: 1) Press & hold setup button, 2) Turn on RX, 3) Status light blinks red then goes solid green, 4) Release setup button and the light stays solid green and stays green. This is as far as I've been able to go on the setup procedure no matter how many times I try to start over from the beginning. Without the ADFc2 plugged into the RX the motor, rudder, planes, ballast vent, and pump for blowing ballast work normally. When I plug the ADFc2 into the RX, everything works normally except the planes. What can you suggest please?
SSBN659
"Will" Rogers
Comment