David,
These look like V-cup seals and I want to make sure I install them right. See my question below.
Bill
-------------------------------------
Bill
I can’t remember which way round they go. I THINK it is with the brass on the inside, but then again, I seem to remember that Merriman said he uses O Rings, so it won’t make any difference.
Suggest you pose the question on Merriman’s forum
D&E MINIATURES SUPPORT
Its a good question that a number of people would like to know the answer to.
Mike Caswell Join our new Model Makers Forum! http://forum.sub-driver.com
Hi Mike,
I just received my order this morning and need to confirm the proper direction for installing the seals. Does the bronze end go inboard and the seal end outboard?
Bill Rogers
These look like V-cup seals and I want to make sure I install them right. See my question below.
Bill
-------------------------------------
Bill
I can’t remember which way round they go. I THINK it is with the brass on the inside, but then again, I seem to remember that Merriman said he uses O Rings, so it won’t make any difference.
Suggest you pose the question on Merriman’s forum
D&E MINIATURES SUPPORT
Its a good question that a number of people would like to know the answer to.
Mike Caswell Join our new Model Makers Forum! http://forum.sub-driver.com
Hi Mike,
I just received my order this morning and need to confirm the proper direction for installing the seals. Does the bronze end go inboard and the seal end outboard?
Bill Rogers
Comment