Welcome to our forums. For the best in R/C submarine kits, components and accessories, be sure to visit the Nautilus Drydocks
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Mounting servos in the Forward compartment of the Sub Driver
What would be the secret of getting the two center bulkheads out and then reinstalling them?
Thanks
Ernie
Remove the two servo pushrod wheel-collars, unscrew the ballast servo securing strap and pull it out (long hemostat is your friend here), remove emg. ballast blow valve (if installed), remove all ballast bulkhead securing screws, grease inside of cylinder within forward and after dry spaces, use a screw driver through open flood-drain holes to unseat bulkheads and slide them forward and after for removal.
Comment