Welcome to our forums. For the best in R/C submarine kits, components and accessories, be sure to visit the Nautilus Drydocks
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Mike said he thinned down some spot putty with lacquer thinner and brushed/dobbed it on then lightly sanded it to knock off the high points. He didn't even sand the 3D printed hull prior to that.
So that was you Steve who explained it to me. Good to get it out here to all. I see some more testing, practicing and trail & error on a test-article in my future.
And yes, big thank you to Bob and Jason for putting this event on!
Comment