Skydiver 6 foot new build.

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Tom Martin
    replied
    So impressive! The Lipos video, with the correct digital editing could be a new episode of the show! (Minus the water foul, the fisherman and the person trying to feed your craft.)
    Tommie

    Leave a comment:


  • RCnut
    replied
    Going to test tomorrow (Sunday 7th) Hope for the best :)

    Leave a comment:


  • greenman407
    replied
    Looks great! I hope that they are big enough

    Leave a comment:


  • RCnut
    replied
    Ok Just replaced the Graupner Jets, they were failing under the load, So I have installed New Kehrers, I am keeping the Brushless motors so a direct comparison can now be made between the two different Jet drives. I have fabricated a waterproof Box Just for the motors and jets and if this works as well I will be thinking of ways to get this beast under water in the future.
    Attached Files

    Leave a comment:


  • RCnut
    replied
    Thank you guys, Hmmm I was quite happy with the PBs, I'll pass along the compliment to Mrs RC nut, She just learning about zooming in and out on her phone lol.

    Leave a comment:


  • greenman407
    replied
    Yep, the lipos move her along better, for sure. Can you go 6s? That might get her up out of the water a little more. The Mrs. is a pretty good camera man....er woman.

    Leave a comment:


  • He Who Shall Not Be Named
    replied
    Magnificent, Mamas. Glorious! What a pleasure to watch. Thank you.

    M

    Leave a comment:


  • RCnut
    replied
    Went out yesterday and this is what transpired :)

    This one first, 12 volts PB Batterys



    Next, 4 cell Lipos

    Leave a comment:


  • Tom Martin
    replied
    RC:
    While you're making trim adjustments, perhaps you could add torpedoes or mini Gatling guns to clear out those pesky swans!

    Tommie

    Leave a comment:


  • RCnut
    replied
    Nope, no foam, I'd rather do it so If I decide later on to stick a trim tank in there I can. So just block up the holes :)

    Leave a comment:


  • Subculture
    replied
    Perhaps you could fill it with expanding pu foam. it will add a small amount of weight, but minimal and will make it waterproof.

    Leave a comment:


  • RCnut
    replied
    I'm thinking to just Seal up the Sky 1 so no water can get into it, Also re position the equipment inside further back. I'm also thinking of going over to lead acid Batteries which will give me less speed but more duration and are also not bothered by water so much.

    Leave a comment:


  • Tom Martin
    replied
    Shouldn't be too difficult a fix and she'll be good to go! Perhaps a bit of foam in the SKY and a little lead in the DIVER. Then back to the water to scare some swans.

    Tommie

    Leave a comment:


  • greenman407
    replied
    Remember what happened in episode "Sub-Smash"? Straker said that Sky1 cannot be launched if more than 10 degrees down. Better get it right Mister or youll have Colonel Fraser propelled into the sea floor. OOOPPPSSS!

    Leave a comment:


  • Subculture
    replied
    That skyone will never fly!:)

    Leave a comment:

Working...