Time I started this build thread. I have been given a new dive module to test run in a model. This build was supposed to be straight out the box. So I took a break from my other sub project to get on with this quick job. ..As usual though I couldn't resist putting my mark on this build and have already started modifying the kit.
Progress so far: started by fitting running gear whilst stern is still accessible. Stainless steel shaft running in brass bearing. This didn't go smoothly - even though I drilled the brass through on my model lathe the hole ended up very 'scorred' inside, like the rifling of a gun barrel! (Are there special drills which make nice smooth holes in brass?) So I ended up drilling the brass bearing oversize and purchased a ready made bronze bush which is a nice snug fit. Runs nice and smooth. I went for the seven bladed scimitar prop because Skipjacks converted to them part way through their service life, and mine is going to be Shark in her final refit form.
Comment