AD2 Override Fail

[Wax Savage]

Bruce,

much as I want to give your idea a go, I cannot figure out how to momentarily pull the signal wire out of the servo connector and...

[Wax Savage]

An FYI to all that Kevin McLeod responded to my initial email within 2 hours of my emailing him. Unfortunately, I was unaware of this. My email service...

[Wax Savage]

Hi Bruce and MFR1964,

thanks for the input.

MFR1964.., my brushless motors do not have added on capacitors soldered to the case....

[Wax Savage]

Hi BruceM,

thanks for your response. I read your AD2 saga closely. I agree that 11 seconds to fully wake up your system electronics certainly...

[Wax Savage]

Thanks for the suggestion,

I just emailed Kevin McLeod about the AD2 override problem. I'll post again after he responds.

[Wax Savage]

Thanks for the response. I have not tried swapping RX channels but, will test it out tomorrow. AD2 sensitivity is on number 2.

It crossed...

[Wax Savage]

I have a new AD2 purchased from Nautilus Drydocks. The AD2 is mounted to the aft equipment tray of my R&R WTC and lays alongside the ballast pump....