KMC -Snort Pump Controllers -can you Y cable these with a servo?

[Slats]

Hi Kevin,
I currently have the Snort controller occupying a channel on its own. As it works (as it should), on one half /side of a fully proportional channel, I was wondering if I could y harness this to the RX and use a servo on the same channel for an auxiliary function, like periscopes?

Many thanks

John

[KevinMc]

Hi John,

Absolutely you can, but of course the servo will still work over the full travel range of the channel.

[Slats]

Thanks Kevin,
I thought that would be the case, I didn't want to try it however until I asked, as I was concerned that it might screw the unit up.
Thanks
J