Tweet
David,
Im doing the assembly on the Revell Gato Subdriver and I would like to know if there is anytihing I need to know or do when using the 11.1 volt battery supply? Or, can I just do the same electrical hook up as we did on the 7.4 volt seawolf and type VIIC, just adding the additional channel and servo for the retract opperation?
I and I'm sure others would like you and or Kevin to post a good quality wiring diagram for both the 6 channel installation and also the 7 channel like the Gato when an ADF, Lipo Guard and LPB are installed.
Regards,
Myron
Im doing the assembly on the Revell Gato Subdriver and I would like to know if there is anytihing I need to know or do when using the 11.1 volt battery supply? Or, can I just do the same electrical hook up as we did on the 7.4 volt seawolf and type VIIC, just adding the additional channel and servo for the retract opperation?
I and I'm sure others would like you and or Kevin to post a good quality wiring diagram for both the 6 channel installation and also the 7 channel like the Gato when an ADF, Lipo Guard and LPB are installed.
Regards,
Myron