so after a lon gset of issues.i now have a wfly wft09 so I can set end points(after I read how too) I seem to have burnt up the shaft seal for the props as I have an leak in the engine room and after putting a hose on the valve stem on the outside of the rear bulkhead and blowing the moter shafts are the only place I get bubbles..so I need to know what seals to order. for spares.also is there some instrutions for changing out the shaft seals for the subdriver....I did get the lpb plumbed in finaly for trimming but the leak stopped that.. so nowthats where I am..or should I return it to the pens for the experts to repair??????
need some info
Collapse
X
-
Tags: None
-
Let me fix it. David Merriman, 835 Holly Hedge Ave, Virginia Beach, VA 23452. Just send me the motor bulkhead with attached equipment tray, nothing else. Oh .... and a note telling me what needs fixing.Who is John Galt? -
-
-
Excellent. If the seals are the only problem, I'll have that bad-boy turned around in one working day.
M
Who is John Galt?Comment
-
your the best....I will try try my best to keep drydock overhauls from bad captining to a dull roar in the futureComment
-
Comment
-
-
Comment
-
-
just finaly got back from a week lonk set of classes on hybrid and electric car transmission classes out of state and thought I would check in.and see if there is an update?Comment
-
just getting over a terrible bout with the flu. This week. Sorry for the delay.
DavidWho is John Galt?Comment
-
-
Comment
-
Comment
Comment