does anyone have an OTW cylinder instruction manual

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • SVilling
    Lieutenant, Junior Grade
    • Oct 2024
    • 16

    #1

    does anyone have an OTW cylinder instruction manual

    Hello!
    I am looking at replacing or getting spare orings for an OTW cylinder and was wondering if there is a 'users manual' available, please?

    Thanks all!
    Steve Villing
  • Subculture
    Admiral

    • Feb 2009
    • 2646

    #2
    They're just bog standard rings. What diameter is the cylinder 11cm?

    Comment

    • SVilling
      Lieutenant, Junior Grade
      • Oct 2024
      • 16

      #3
      Looks like it. Best estimate on the orings there are 100ID and 106OD, but I can’t find that exact size easily, maybe making 100ID and 2.65mm cross section the most likely? Also used AS007 to replace water sensor orings.

      Comment

      • Albacore 569
        Captain

        • Sep 2020
        • 973

        #4
        Here is a drawing The great man himself Bob made for me before he passed of the shaft seals These are the best, but now we all got to share whatever we can with each other.

        Click image for larger version  Name:	motor mount.jpg Views:	0 Size:	49.9 KB ID:	198680
        Last edited by Albacore 569; Yesterday, 08:21 PM.

        Comment

        • Subculture
          Admiral

          • Feb 2009
          • 2646

          #5
          The cylinder seals were usually nitrile o-rings, 3mm cross section. You could also use silicone o-rings for the cylinder seals, they tend to be a little softer than most nitrile o-rings, and are more resistant to ozone.

          O-rings are sized on the internal diameter if you buy them from a professional supplier, for a 11cm/110mm diameter cylinder with 3mm wall thickness you will want o-rings sized from 100-104mm ID with a 3mm cross section. it’s okay and even preferable to have the o-ring stretch a little as it helps keep them in place, but you shouldn’t exceed 5% of the internal diameter in stretch to maintain longevity of the seal with 1-2% being the sweet spot.

          If you buy them from places like Amazon and eBay be careful as a lot of sellers there often use unconventional sizing e.g. they’ll specify the outer diameter of the o-ring rather than the internal. This can leave you with a seal oversized or too small depending on what you are using it for.

          Comment

          • Subculture
            Admiral

            • Feb 2009
            • 2646

            #6
            Bob didn’t make the cylinders. I once met the chap who made them at a model engineers show many years ago now, I can’t recall his name but he was very much into 1/6th scale land based R/C military models- tanks, jeeps etc.

            In the early pre-millennium days of OTW, Brian Cornelius of Craycraft made the cylinders, but he switched to producing training rigs for gas installers. More lucrative apparently.

            Those who’ve been around in this hobby since those times will recall there was a period of about three or four years when commercial wtc’s became a scarce commodity.

            Comment

            Working...