Tweet
I pluged my WFly recevier into my servo leads on my new Seaview SD, pluged my Vislero 7.4V battery in. No chatter on the servos, just a tiny bit of servo hum from the gas servo, I am sure it can be tweekd to stop.
Filled my bath tub up with water and submerged the Seaview SD! Gave a little left stick and the gas system dumped some gas into the SD, and the right stick, lots of air bubbles escaped from the top of my SD.
Though my Seaview is not built, am I safe to assume it does not take much gas(short burst)to raise the sub and than a few hits with the air release to sink it agian?
This was my first experince with such a system, it seemed to work and am very happy.
Thank you Mike for having these systems available to us modelers and your great service and to Dave for making such nice SDs and fitting kits for our models. Hope to get this Seaview built soon and get out and play with it.
Hooked for life!
Filled my bath tub up with water and submerged the Seaview SD! Gave a little left stick and the gas system dumped some gas into the SD, and the right stick, lots of air bubbles escaped from the top of my SD.
Though my Seaview is not built, am I safe to assume it does not take much gas(short burst)to raise the sub and than a few hits with the air release to sink it agian?
This was my first experince with such a system, it seemed to work and am very happy.
Thank you Mike for having these systems available to us modelers and your great service and to Dave for making such nice SDs and fitting kits for our models. Hope to get this Seaview built soon and get out and play with it.
Hooked for life!