Making stuff

[Lockleer1]

To someone who’s never seen this before, it is so, so interesting. Thank you very much for clarifying! [and for email]

Anytime sir!

[Lockleer1]

So i made a couple of short videos (in order top to bottom) to better illustrate the process of making the gears i made up for the Blueback/and a friend. Enjoy!

https://www.youtube.com/watch?v=WqjinBLI2A0

https://www.youtube.com/watch?v=QHugZMAntTA

https://www.youtube.com/watch?v=CtKF4jsWX2o

https://www.youtube.com/watch?v=k_MfkBtdTtg

[Lockleer1]

Had a buddy ask about an alternative to the bellows seals for the OTW endcap/bulkheads and specifically asked about the packing gland seals i use. I'll post some pictures of it later but i made a packing gland like i use for my bulkheads with a 6MM thread so it can be adapted into the OTW end caps. I'll send it to him and will see how it works out.

[Lockleer1]

Here's the fitting for OTW control rod replacements, I just have to cut off and put male thread for 6MM 1.0 so it can be installed onto the OTW end caps. I'll put a washer with a second ring as well for redundancy within the fitting. I'll add picture later when I get the rest completed.