Tweet
I have been 3D printing since 3d printers were first available back when you built your own with lumber and threated rods. I like submarines and especially the Russian Typhoon. I was in the US Navy and served on USS Permit and USS Haddock. This is my first submarine project and I do a lot of mods and remixes and have some ideas to share with the Typhoon.
My first request is where to purchase motors, props and associated stuff - I have no idea what motors to use on the 1:144 Typhoon or where to get them. I am going to mount the motors to hull 2 so they will be in the wet side. Thanks
I have already modified hull 1 and 2 to be bolted together instead of glued - great tight fit. Allows disassembly and access to linkages.
BTW - I am a builder not a detailer so I don't get into the finer finishing details.
My first request is where to purchase motors, props and associated stuff - I have no idea what motors to use on the 1:144 Typhoon or where to get them. I am going to mount the motors to hull 2 so they will be in the wet side. Thanks
I have already modified hull 1 and 2 to be bolted together instead of glued - great tight fit. Allows disassembly and access to linkages.
BTW - I am a builder not a detailer so I don't get into the finer finishing details.
Comment