Mtroniks ViperMarine10 ESC failure

[B800Kaluga]

Sanding and filling has been completed, and I've got the first coat of primer on. For this build I'm using automotive filler primer to help fill in the...

[B800Kaluga]

I found these on CGtrader. They're in 1/72, however upscaling each part by 150% in your slicer should do the trick. I'm also not sure how RC friendly...

[B800Kaluga]

Firstly, Thank You for doing all of this research and math on behalf of the community, I have been lurking around the forums for some time now, and I...

[B800Kaluga]

Over the past few days I've gotten bottom part of the hull filled and sanded. I also started to fill and sand the upper hull as well as clean up the WTC....

[B800Kaluga]

Looking back I made a few mistakes. No fuse, and the battery lead wire was way too thin. Fortunately I only lost one ESC and a servo, but my 75MHz Rx...

[B800Kaluga]

I also really like the Scorpene-class, they're my favorite class of submarines, and its a shame that there aren't more of them in service. I had Bob draw...

[B800Kaluga]

As mentioned in my 1/72 Scorpene build post, I had an unusual failure of a ViperMarine10 ESC. I'm using a R&R 70mm WTC and the ballast pump ESC is...

[B800Kaluga]

Hello Everyone! My name is Eric and I am currently in the process of constructing a 1/72 Scorpene. This will be my second submarine build, the first being...