3D Printed Baking Powder Sub

[TuptubBuilder]

I'm most impressed with the slotted keel used for trim. Very novel.

[TuptubBuilder]

HT-PLA FYI: https://www.youtube.com/watch?v=bnjVVY0om48&t=70s...

[TuptubBuilder]

Thank you for the information. I have successfully used IGUS bearings back in the day. It might be worth noting that reaming should occur after press...

[TuptubBuilder]

If it isn't too much trouble, could you provide a URL? I am interested in dimensions and tolerances. I will note that, back in my day, 300 series stainless...

[TuptubBuilder]

If you reside in the USA, McMaster-Carr. Shipping is expensive so I batch my orders. ...

[TuptubBuilder]

Has anyone tried HT-PLA? It sounds too good to be true. It prints just like PLA but annealed, it is thermally resistant to 150 C.

[TuptubBuilder]

I just ordered Polymaker Polylite ABS. It's supposed to be less toxic when printing. I've had great success with other Polymaker filaments such as PLA...

[TuptubBuilder]

For those of you old enough to remember the toy Nautilus that was found in cereal boxes
BPsub.mp4